How to Load a Nail Gun [Step by Step]

You are bound to hammer your fingers accidentally while driving hundreds of nails in the wood with the good old hammer as part of your job. It is painful and time-consuming. So the more economical option is to get yourself a new nail gun.

Right out of the box, it will look like a dream come true, but you will find yourself in jeopardy when it comes to loading the nail gun. Learning how to load a nail gun may seem like a very intimidating task at first, given the highly unhelpful user manual and your lack of knowledge.

But here’s a treat, it is as simple as it can be. Some may even say that it’s a piece of cake. You just have to learn the proper technique to do it and believe me, once you get the hang of it, you will be surprised how easy things become.

Only to get everything out in the open and help you out in the best way I can, I am about to break down the complete procedure into simple steps. You just have to read each step very carefully and follow it accordingly. And within minutes, you will be ready to get your nail gun prepared to roll.

How to Load a Nail Gun

So, without wasting any more of your time, let’s delve into the details.

Step 1: Unplug The Nail Gun

The first thing that you need to be very concerned about, above all, is your own safety. You can get seriously electrocuted if you try to load your nail gun while it is still plugged into the power switch. So, always remember to switch off the power source and unplug the nail gun from the switchboard before you proceed to load your nail gun.

Step 2: Check Out The Magazine

The next thing you need to do is inspect and evaluate how your nail guns magazine works. You should be able to get the magazine out in one sliding motion, and if you can’t, it means that it is faulty, and you must get your gun replaced.

However, if your magazine works fine, just make sure that it doesn’t have any nails already loaded in it. This will reduce the likelihood of a possible jam.

Step 3: Choose The Right Sized Nails

Choosing the right size of the nails is the most crucial part of this process because if you are not careful, you may end up getting a size bigger or smaller than your nail gun. This will result in the most irritating jams ever. So, always remember to get the proper size of the nails. If you have difficulty in determining the correct size, you may refer to the manual.

Step 4: Load The Magazine

The correct way to do this is to hold the gun pointing away from you and unload the magazine. Next, pull the spring of the magazine downwards until it is locked in place. Doing so would expose the gap for the nails to be loaded into the magazine.

You will notice that the hole in the magazine is shaped so that the nails can go into it only in one way. So, just keep adding nails into the magazine until it is full.

Step 5: Finishing The Job

Once the magazine is full, load the magazine into the gun. Only when it is safely packed and loaded can you proceed to plug the switch into the electricity board to get started on your work.

Remember to keep the gun pointed at the wood or the wall you are working on and never on anyone because it can cause severe damage. When you are done, unplug the switch, lock the gun, and put it out of reach of children.

Frequently Asked Questions

How do you load a nail gun?

Loading a nail gun is simple. All you have to do is follow a few simple steps, and you are done. The first and most crucial step is to unplug the nail gun. Then inspect the magazine to understand how it runs. After that, you can quickly load the nails into the magazine, and Voila! You are ready to roll.

Conclusion

Assuming that you read the complete articles very carefully, you are now fully aware of adequately loading a nail gun. I have tried my very best to explain each step in the easiest way possible. Make sure to follow each step carefully and never skip any action in a hurry because your thoughtlessness can result in severe damage to yourself and others around you.

Leave a Reply

Your email address will not be published.